Apart from blow up printers, the one scariest thing for me about a slicer is losing settings. You spend hours getting your printer dialed in, specific profiles per material and then…

You update your slicer software and it all goes away. I have now learned Cura does this. And does this a lot. Forum posts abound about it. Friends recommend I switch to Prusa because it happened to them. Unfortunately too late for me to write down my old settings, and they’re apparently not in the ~/.config/cura folder anymore. Nice.

  • Carighan Maconar@lemmy.worldEnglish
    3·
    9 months ago

    Never had this problem I’ll admit, working with it on Windows. But there’s also the backups plugin I’ve been running since day 1, so in case this ever happens eh, should be good.

    • fmstrat@lemmy.nowsci.comOPEnglish
      0·
      9 months ago

      Did the backup plugin work between 4.x and 5.x? If so, perhaps I will try that during my transition, too. I have backups of the configs in my dotfiles, it’s just that Cura doesn’t import them between major versions.

      • Stampela@startrek.websiteEnglish
        1·
        9 months ago

        I’ve never had issues with Cura losing my stuff (been using it with an Ender 3 since… 2019 I think) but the backup plugin is connected with your account. It’s a wonderful thing! New computer? Login, restore backup, everything is like you left it.

        I do make sure to use it before any update because I have seen the same kind of posts as you have.