If you don’t know what lightning infill is, it was made by Cura and was added to PrusaSclicer.
I chose to print with it since it showed up as a tool tip. Hoping has the same infill strength as Gyroid as it’s suppose to use less filament (estimates is around 5 grams for this part). It was suppose to also save time, but it instead added 10 min.
New Lemmy Post: Trying out the Lightning Infill for the first time, so far so good (https://lemmy.world/post/11766250)
Tagging: #3dprinting
(Replying in the OP of this thread (NOT THIS BOT!) will appear as a comment in the lemmy discussion.)
I am a FOSS bot. Check my README: https://github.com/db0/lemmy-tagginator/blob/main/README.md