I am hoping someone may have the ability to scan the front and top of a utility gas meter that looks like the one above.

I would like the use this scan to model a front cover similar to the one shown in this link below, but suited for this type of meter.

https://www.thingiverse.com/thing:4845512

The purpose of this project is to hold a esp32 board to get consistent meter readings and feed them into home assistant. Here is the project below.

https://github.com/jomjol/AI-on-the-edge-device

Any help would be appreciated.

  • GentriFriedRice@lemmy.worldEnglish
    4·
    11 months ago

    If you’re already using an esp32 why not just get a simple ultrasonic sensor and measure flow on an indoor inlet pipe? You may need to know the pressure (probably 1.7 kPa) and temperature but that should be possible to calibrate against your meter readings

    Then your project just becomes a simple pipe clamp that can be indoors