Both glowing portions are natural gas pipes. Perhaps it’s somehow ignited inside the pipes and is super heating them but also somehow NOT travelling outside the two glowing sections and burning the house down???
Both glowing portions are natural gas pipes. Perhaps it’s somehow ignited inside the pipes and is super heating them but also somehow NOT travelling outside the two glowing sections and burning the house down???
*ahem Subtle Spell has entered the chat. Cast any spell that doesn’t require a line of sight target and that doesn’t require material components or otherwise rely on an “attack” or similar action. Like say Guardian Of Nature. Or, if you want to get REALLY pedantic: Dimension Door.
Adding repos can just be done inside a Toolbox, or even as Overlays. Grub can also be edited and changes applied to immutable OS’s like Bazzite/Kinoite. I’d definitely say give it a shot on a non-daily driver machine and see how you like it. Having the option to mess with the underpinnings can be nice- but not having to has a lot of value as well.
I know, right? It’s so hard to “really” mess something up and Toolboxes are very cool for things not served by Flatpaks or Overlays.
Regarding your not wanting to go with an immutable distro: what configs are you thinking you’ll need to mess with that makes an immutable distro a bad idea exactly? I was previously on the fence about it as well but Bazzite has absolutely served my needs and requires way less fiddling than my previous Nobara install did after major updates. I have yet to find any day to day configurations that I haven’t been able to overcome with OSTree overlaying. Aside from being immutable, Bazzite literally checks every other box you’ve got listed.
I believe it’s more a “the PS3 CPU architecture was an absolute nightmare and emulating it is difficult/slow” more than it had anything to do with the graphics rendering portion- which is typically where phones would have made the most substantial advancements. There are specific instruction sets that need to be supported by any CPU emulating PS3 to run anywhere near native speed… And I don’t believe much work has been done for ARM cpu’s to support the needed instructions in mobile devices.
Same boat as you. The HOA maintains a pathway in a wetlands reserve right behind the residential area and it costs less than $20/mo.
They don’t really care what you do besides the following: no farm animals/chickens, no structural changes to the homes without a licensed contractor performing the construction, shoot an email to the HOA if you’re going to replace your roof or repaint your house to keep SOME level of uniformity.
Mostly they don’t care. Hell, the CC&R’s and HOA incorporation docs literally say they won’t directly enforce things against you and leave it up to the neighbors to take you to court with the HOA docs/agreements as free ammo. So if you explicitly want to be a menace to your neighbors/piss people off or want to have the only bright ass neon pink home with custom additions in the entire neighborhood - probably not the place for you. Otherwise they’ve had no effect on myself or my neighbors whatsoever and the wetlands/park is really nice.
Just seemed like a more appropriate fit. As I’m sure we’ve all thought about good ol’ JD eating house pets whilst in the shower. When we aren’t thinking about sultry couches, anyways.
I see we’re doing some better numbers over here in showerthoughts!
Showerthoughts maybe?
Why would I recommend Fileflows? It was a little more user friendly in my experience without requiring pulling in configurations from other sources. I know there are repos chalk full of Tdarr settings and configs, but for simple setups and DIY I preferred the Fileflows interface. The end result is basically the same, so pick your poison.
Isn’t AMD’s HEVC/265 still decent, specifically? I feel like I read that somewhere years back. 264 has always been a weak spot for them, however.
Isn’t this almost the inverse argument to the android vs iPhone thing? Like the iPhone being (traditionally) more expensive for the “same technology from 5 years ago”? I don’t really have a horse in this race, I’m a firm believer in use what you like and is easiest/best for you. But I do feel compelled to call this one out a bit.
I might recommend fileflows over tdarr- but either way some kind of similar solution is almost mandatory with the grab bag of arbitrary encodings you find out there.
Atomic OS’s (especially Fedora based) with Nvidia are going to be a bit of a pain. Did you follow all the instructions found Here ? I personally gave up on silverblue/kinoite after I tried Bazzite. Similar bases, but the Bazzite devs paid special attention to GPU and accessory drivers/implementations that are otherwise much more painful in Fedora Atomics. You can always do a clean rebase then re-run the steps above (only the OSTree section).
Software-wise, it seems that the relatively fast adoption of flatpaks and other containerized formats somewhat solves the typical dependency hell that was so common in Linux just a few years back (and to some extent still is an issue today depending on your distro and use case). The hardware support side is a little harder. That’s going to be up to vendors to play nice with the Kernel team and/or introduce reasonable userland software that doesn’t break the golden rule. Until Linux gets more market share the latter isn’t likely to happen. A nice side benefit of the emergence of immutable and/or atomic distros is that users can play around and try things with much lower risk of bricking their systems, so I’d also consider that a step closer in the “it just works” department.
Xbox controllers (Xbox One and newer) have been absolutely solid for me with the xone driver + xpadneo, regardless of distro. Bazzite has everything I need baked in, so it was completely plug and play. Not a very interesting answer, I know. But it still blows me away that it “just works.”
Very true. But brute force checking through tons of different settings for each camera you need to configure is not fun. I couldn’t seem to find any kind of “known working configs” database or anything either. Every camera seems to be different in what it expects, outputs, authenticates, etc. Once it’s set up, I agree, maintaining the config is easier. Having all your cameras match in model and firmware version probably makes the whole endeavor MUCH easier.
AmCrest and Frigate together are SO good. Integrating Frigate with Home Assistant was also insanely easy for quick viewing and notifications. That initial Frigate config is a bit of a bear- but once you’re past that I cannot speak more highly of it.
Oh baby, time to proselytize the masses of Lemmy and introduce a whole new set of suckers to “Fido”. It’s zombies with big Fallout vibes and is unironically one of the best C to B tier movies I’ve ever seen. It’s the kind of movie where it looks like everyone involved was just having fun with it, ya know? Check it out and make sure to let me know what you think!