deleted by creator

As per usual, the fine becomes simply the cost of doing business

I’m sure this will about as effective as D. A. R. E. in American schools and keeping people off drugs

Maybe because I didn’t know what I was doing back then but that was the only way I used Limewire

Fucking studfinders man…

Thanks I’ll give some of these suggestions a try. I am printing with PLA at the same temps I’ve used in the past with the same material. I wouldn’t think the change to pei would require a changing of print temp but I’ll keep that in mind as well.

Rather than setting up a VPS like some of you is there a reason I couldn’t run this on my existing home unraid server?

Kingroon KP3S here. Totally stock. No issues with it, always had good quality from it out of the box. I want to add a touch sensor and klipper to it but haven’t had the time to figure it out